Nostalgia

Which depots were you at and where did you start?

Started as a 2nd person at Lithgow in 1988, went into the ETR school in early 1990 and was appointed Driver at Central in late 1990.

Spent 9 years at Central before transferring to Blacktown in 1999 where I spent the next 24 years before retiring in 2023.
 
The Red Rattler.
Yep, though the term Red Rattler originated in Victoria with their electric suburban rolling stock that began operating in 1919 and the term was later adopted here.

More of a challenge compared to the modern stock of today, being 1926 technology they were very basic in operation but good to drive though with their older braking system they could be a bit of a challenge coming off the Harbour Bridge on the steep downhill into Wynyard.
 
Yep, though the term Red Rattler originated in Victoria with their electric suburban rolling stock that began operating in 1919 and the term was later adopted here.

More of a challenge compared to the modern stock of today, being 1926 technology they were very basic in operation but good to drive though with their older braking system they could be a bit of a challenge coming off the Harbour Bridge on the steep downhill into Wynyard.
Do you own a train set?

The bro Inlaw just inherited his uncle’s train set. He has set it up about the back shed next to his slot car track.
 
Do you own a train set?

The bro Inlaw just inherited his uncle’s train set. He has set it up about the back shed next to his slot car track.
Not yet, only retired in 23 and in the process of moving to rural Victoria, once set up there will most likely, though model railways can be a very expensive hobby, an Australian locomotive will set you back between $300 and $900 per unit depending on the manufacturer, the type and if is DC or DCC.

A new 7 car XPT set will set you back between $1400 (DC) and $1650 (DCC), will usually cost even more on the 2nd hand market once they sell out, a 4 car Red Rattler set costs upwards of $595.
 
The only problem with the old round jaffle irons is with the large amount of wastage with the outside edges of the bread.

They end up looking pretty but from a practicality point of view, the square ones have to be better.


square jaffle.jpg
A double is even better, but I have to admit that this triple round would be handy to have if you were planning to do something with those 3 cans.

triple.jpg
 
Back
Top